Wrap - Installation Instructions

SimplyGoodCoffee Brewer Wrap Installation Guide

Read all the instructions and see images and tips at the end for additional insight.
Unroll the wrap, reverse rolling if necessary to flatten.
Empty your brewer, remove removable parts, drain upside down, and dry thoroughly.
Ensure brewer surfaces are free from coffee stains, water, and grease.
Work on a clean, flat surface with a towel beneath your brewer.

Peel wrap from backing carefully to avoid sticking to itself.
Align the bottom edge of the wrap precisely with the brewer base and square opening around buttons.
Press gently below buttons; do NOT press firmly until alignment is perfect.
Tip: Misaligned? Peel carefully and reposition until exact.

Gradually press wrap upward above the buttons, starting from the middle, moving outward to sides.
Eliminate bubbles and creases with fingers or plastic card (covered in cloth or sock recommended).
Smooth wrap evenly toward top edges and around sides.
Tip: Stand brewer upright once sides are secure for easier handling.

Before sticking the Gasket in place, prior to peeling off the backing, fit it in place. There may be better orientation for the best fit.
Peel backing from gasket provided.
Carefully position around front buttons to neatly hide gaps.

Second Person: Helpful for alignment, holding, or repositioning.
Alignment Critical: Bottom and button area must be perfectly straight initially.
Avoid Rushing: Take time to press bubbles out progressively. Do not press the wrap down too firmly until any bubbles are gone.
A customer who helped us test the wraps suggested using a very small pin, making a tiny hole to let any air out of nasty bubbles. He says you cannot see the pin hole.
Card Trick: A plastic card wrapped in cloth or sock can help smooth bubbles.